Particle Animator (Legacy)

Particle Animators move your particles over time, you use them to apply wind, drag & color cycling to your particle systems.

Properties

Details

Particle Animators allow your particle systems to be dynamic. They allow you to change the color of your particles, apply forces and rotation, and choose to destroy them when they are finished emitting. For more information about Particle Systems, reference Mesh Particle Emitters, Ellipsoid Particle Emitters, and Particle Renderers.

Animating Color

If you would like your particles to change colors or fade in/out, enable them to Animate Color and specify the colors for the cycle. Any particle system that animates color will cycle through the 5 colors you choose. The speed at which they cycle will be determined by the Emitter’s Energy value.

If you want your particles to fade in rather than instantly appear, set your first or last color to have a low Alpha value.

Rotation Axes

Setting values in either the Local or World Rotation Axes will cause all spawned particles to rotate around the indicated axis (with the Transform’s position as the center). The greater the value is entered on one of these axes, the faster the rotation will be.

Setting values in the Local Axes will cause the rotating particles to adjust their rotation as the Transform’s rotation changes, to match its local axes.

Setting values in the World Axes will cause the particles’ rotation to be consistent, regardless of the Transform’s rotation.

Forces & Damping

You use force to make particles accelerate in the direction specified by the force.

Damping can be used to decelerate or accelerate without changing their direction:

• A value of 1 means no Damping is applied, the particles will not slow down or accelerate.
• A value of 0 means particles will stop immediately.
• A value of 2 means particles will double their speed every second.

Destroying GameObjects attached to Particles

You can destroy the Particle System and any attached GameObject by enabling the AutoDestruct property. For example, if you have an oil drum, you can attach a Particle System that has Emit disabled and AutoDestruct enabled. On collision, you enable the Particle Emitter. The explosion will occur and after it is over, the Particle System and the oil drum will be destroyed and removed from the scene.

Note that automatic destruction takes effect only after some particles have been emitted. The precise rules for when the object is destroyed when AutoDestruct is on:

• If there have been some particles emitted already, but all of them are dead now, or
• If the emitter did have Emit on at some point, but now Emit is off.

Hints

• Use the Color Animation to make your particles fade in & out over their lifetime - otherwise, you will get nasty-looking pops.
• Use the Rotation Axes to make whirlpool-like swirly motions.