The Unity QNX Player supports input via touch devices. To enable this, make sure you meet the following prerequisites and operating system configuration requirements.
mtouch (QNX 7.0 doc / QNX 7.1 doc) service is running.As the QNX Unity player requires the touch coordinates to be in screen coordinates, configure the following setup in the scaling.conf file:
scaling.conf (QNX 7.0/QNX 7.1) file to use screen coordinates. For example, if you have a 1366x768 display, set mode:scale for the display resolution to scaling.conf: 1366x768:mode=scale.mtouch service.If you have installed the events (QNX 7.0/QNX 7.1) utility on the QNX image, you can use it to verify if the touch service is set up correctly. The reported coordinates (pos) should be in the range [(0,0), (DisplayWidth, DisplayHeight)].
If the coordinates are outside the range, check if the scaling mode in scaling.conf is correct and the touch device specific parameters in the mtouch.conf (QNX 7.0/QNX 7.1) file are matching the used device.