Set Pivot icon Set Pivot (Edges)

Use the Set Pivot action to move the pivot point of this Mesh to the average center of the selected edges.

Tip: You can also launch this action with the Ctrl/Cmd+J shortcut, or from the ProBuilder menu (Tools > ProBuilder > Geometry > Set Pivot).

Centering the pivot on selected Edges

In this example:

  • Left panel: The pivot point of the door is at its bottom-left corner.
  • Middle panel: Two edges are selected on the opposite side, so the Set Pivot action changes the pivot to the center of those top edges.
  • Right panel: The pivot point is now at the top right, even when in Object editing mode.