Version: 2022.3
Language : English
Create a ragdoll
Cloth

Joint and Ragdoll stability

This page provides tips for improving JointA physics component allowing a dynamic connection between Rigidbody components, usually allowing some degree of movement such as a hinge. More info
See in Glossary
and Ragdoll stability.

  • Avoid small Joint angles of Angular Y Limit and Angular Z Limit. Depending on your setup, the minimum angles should be around 5 to 15 degrees in order to be stable. Instead of using a small angle, try setting the angle to zero. This locks the axis and provide a stable simulation.
  • Uncheck the Joint’s Enable Preprocessing property. Disabling preprocessing can help prevent Joints from separating or moving erratically if they are forced into situations where there is no possible way to satisfy the Joint constraints. This can occur if RigidbodyA component that allows a GameObject to be affected by simulated gravity and other forces. More info
    See in Glossary
    components connected by Joints are pulled apart by static collisionA collision occurs when the physics engine detects that the colliders of two GameObjects make contact or overlap, when at least one has a Rigidbody component and is in motion. More info
    See in Glossary
    geometry (for example, spawning a Ragdoll partially inside a wall).
  • Under extreme circumstances (such as spawning partially inside a wall or pushed with a large force), the joint solver is unable to keep the Rigidbody components of a Ragdoll together. This can result in stretching. To handle this, enable projection on the Joints using either ConfigurableJoint.projectionMode or CharacterJoint.enableProjection.
  • If Rigidbody components connected with Joints are jittering, open the Physics window (Edit > Project SettingsA broad collection of settings which allow you to configure how Physics, Audio, Networking, Graphics, Input and many other areas of your project behave. More info
    See in Glossary
    , then select the Physics category) and try increasing the Default Solver Iterations value to between 10 and 20.
  • If Rigidbody components connected with Joints are not accurately responding to bounces, open the Physics window (Edit > Project Settings, then select the Physics__category) and try increasing the Default Solver Velocity Iterations__ value to between 10 and 20.
  • Never use direct Transform access with Kinematic Rigidbody components connected by Joints to other Rigidbody components. Doing so skips the step where PhysX computes internal velocities of corresponding Rigidbody components, making the solver provide unwanted results. A common example of bad practice is using direct Transform access in 2D projects to flip characters, by altering Transform.TransformDirection on the root bone of the rig. This behaves much better if you use Rigidbody2D.MovePosition and Rigidbody2D.MoveRotation instead.
  • Avoid large differences in the masses between Rigidbody components connected by Joints. It’s okay to have one Rigidbody with twice as much mass as another, but when one mass is ten times larger than the other, the simulation can become jittery.
  • Try to avoid scaling different from 1 in the Transform containing Rigidbody or the Joint. The scaling might not be robust in all cases.
  • If Rigidbody components are overlapping when inserted into the world, and you cannot avoid the overlap, try lowering the Rigidbody.maxDepenetrationVelocity to make the Rigidbody components exit each other more smoothly.
Create a ragdoll
Cloth
Copyright © 2023 Unity Technologies
优美缔软件(上海)有限公司 版权所有
"Unity"、Unity 徽标及其他 Unity 商标是 Unity Technologies 或其附属机构在美国及其他地区的商标或注册商标。其他名称或品牌是其各自所有者的商标。
公安部备案号:
31010902002961