Audio Clip properties

Use the Inspector window to change the properties of an Audio clip. These properties include the name of the clip, its timing, play speed, its blend properties, the audio file used by the Audio clip, and whether Audio clip loops or plays once.

Display Name

The name of the Audio clip shown in the Timeline Editor window. This is not the name of the audio file that is used for the waveform. The name of the audio file is part of the Audio Playable Asset properties.

Clip Timing properties

Use the Clip Timing properties to trim and change the duration of the Audio clip. Most of the timing properties are expressed in both seconds (s) and frames (f). When specifying seconds to modify a Clip Timing property, all decimal values are accepted. When specifying frames, only integer values are accepted. For example, if you attempt to enter 12.5 in a frames (f) field, it is set to 12 frames.

Blend Curves

Use the Blend Curves to customize the transition between the out-going clip and the incoming clip when blending between two Audio clips. See Blending clips for details on how to blend clips and how to customize blend curves.

When easing-in or easing-out clips, the Blend Curves allow you to customize the curve that eases-in an Audio clip and the curve that eases-out an Audio clip. See Easing-in and Easing-out clips for details.

Audio Playable Asset properties

Use the Audio Playable Asset properties to select the Audio file used by the Audio clip and to set whether the selected Audio clip loops (Loop enabled) or plays once (Loop disabled).

• 2017–12–07 Page published with limited editorial review